1
HiCON Motion Controller / Mach3 and Hicon 7754 Homing error
« on: September 20, 2017, 09:03:11 PM »
Hi,
I setup my lathe with mach3 and Hicon 7754 with plugin version 1.38.01, everything works fine except for the error " ERROR Starting Homing for Axis 0" which i setup the homing for X axis. This is also happened in Y axis. Please help what could be wrong on this. I attached the pictures of my input pin config and the plugin setup with the error.
Thanks,
tonypet
I setup my lathe with mach3 and Hicon 7754 with plugin version 1.38.01, everything works fine except for the error " ERROR Starting Homing for Axis 0" which i setup the homing for X axis. This is also happened in Y axis. Please help what could be wrong on this. I attached the pictures of my input pin config and the plugin setup with the error.
Thanks,
tonypet