Messages

1

General Mach Discussion / Need help with mach 3

« on: September 10, 2017, 01:03:16 PM »

Hi guys,
I've got a problem that I can't seem to find the answer to anywhere.
When you load your code on standard mach 3 and press start my machine moves the Z axis up 20mm to a safe position before travelling down to proceed with the cut.
Problem is I want to run a job which needs all the Z height I can get and I want to change this initial travel to 2mm or so?
Is this possible?

Cheers, Iain

2

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: September 10, 2017, 12:56:17 PM »

Hi,
I've been using mach 3 on all of my home built cnc routers. Currently have a Diy large format cnc router (2mx1.5m) and an openbuilds C-beam XL. Both used for woodworking for my small etsy shop and whatever else I feel like making