Hello Guest it is March 31, 2020, 07:15:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - N2RYD

Pages: 1
1
Thanks I will give  it a try

Bob

2
Hi everyone my father and I just purchased a grizzly g0463 that was converted over to fully cnc x,y,z stepper motors 400 oz/in, gecko drivers, & Mach 3 software.

I am trying to remember back to when I ran a Prototrak for my G &.M code days but that was 17 years ago.  One question I have is how do you move the z axis.  I have the x, y down with the keyboard arrow just can't figure the z.

Thanks

 Bob

Pages: 1