Messages

1

PoKeys / Re: Pokey 57CNC Analog Output

« on: July 15, 2017, 09:57:43 PM »

I figured things out. Came down to just not knowing the Mach4 software, time to hit the books.

Thanks,
Chad

2

PoKeys / Pokey 57CNC Analog Output

« on: July 15, 2017, 07:24:35 PM »

Looking for a little help from the Pokeys users concerning the 0-10v analog output. My issue is i have no voltage when i measure from GNDi and Pin17.

Reviewing my setup using Mach4 an Pokeys plugin 4.2.32.  Under the Pokeys driver configuration on the Misc. tab >PWM Outputs is enabled, frequency set to 20000, Enable pin 17 is checked, Spindle Output is set to Pin17, and a check in the box for "Set to 0 when off"
Under Mach on the output tab> I have Pin17(out) mapped to "spindle on".

In Mach4 GUI control is enabled and spindle is on, and SRO% is @ 100. I can see in the Mach4 log is has sent the variables of "Spindle On" and Spindle FWD" to the Pokeys driver believe after this is a message from the driver ack.

Does something else in the GUI need to be mapped? New to the software so take it easy on me. 

Thanks in advance for any assistance.
Chad