Hello Guest it is March 28, 2024, 04:09:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Piobaire

Pages: 1
1
General Mach Discussion / Mach3 and Boxford Duet
« on: July 10, 2007, 06:51:07 PM »
Hi all !

First time here...
I got hold of two Boxford Duet from a machine dealer, but they're out of software. Boxford seems not to be at any help providing a copy of the orginal disc, as their license agreement prevent them. I've been noticed that the Boxford software sucks, if I should trust some posts I have found. Now is the question if anyone and how much work is there to get a mill and lathe of the Boxford Duet to run on Mach3...

http://www.boxford.co.uk/boxford/docs/products/duet.htm

Any hints from You out there ??   

Very best regards
/Piobaire

Pages: 1