Hello Guest it is August 08, 2020, 02:12:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - kevin.mcca

Pages: 1
Spanish / THC baja hasta el valor min al momento de cortar
« on: July 07, 2017, 02:10:53 PM »
Hola, mi problema es que cuando intento cortar algo el thc baja hasta el valor minimo (por ejemplo: THC min: -1) y hace el corte en -1 y empieza a arrastrar la antorcha por todo el material y me arruina el corte. Hay alguna opcion la cual no estoy poniendo?

Agradeceria mucha su ayuda ya que este problema lo tengo hace varias semanas y ya no se que hacer.


General Mach Discussion / THC Proma compact problem while cutting
« on: June 26, 2017, 01:15:25 PM »
Hi, I've had my CNC table for a while and was working fine until I decided to change the THC min in mach3 and that is where the problem started, first I couldn't change the THC min to a negative value but then I figured it out; when I started to cut something, Z axis goes straight to THC min value and drags the torch all over the material. Already made THC test and works fine. Am I missing a setting that might have changed when I changed THC min?

Pages: 1