1
FAQs / Re: Mach 3 stepper control issues
« on: June 26, 2017, 03:35:00 PM »
enabling the charge pump did the trick!!!
thank you so much! now on to hooking up the other motors.
yea I'm pretty sure they are 24vdc but they shouldn't need much torque as they are on a little baby mill. They were stock from the company Denford that sold the mill.
thank you so much! now on to hooking up the other motors.
yea I'm pretty sure they are 24vdc but they shouldn't need much torque as they are on a little baby mill. They were stock from the company Denford that sold the mill.