Hello Guest it is March 28, 2024, 04:59:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Eugene

Pages: 1
2
MK4 MACH3 Motion Card Problem with output control ports.


I attentively followed installation instructions and to the MK4 and Mach3 setup everything well works: control of motors and ports of input. But ports of an output behave strange: when Mach sends the Torch ON command ports 2-7 when join, Mach sends the Torch OFF command ports 2-7 remain switched on and off only if to finish operation of Mach3, in case of next run of Mach3 ports 2-7 are switched off until it is sent a dresser of "Torch ON"

P.S. I have downloaded the latest version of Mach3 from the official site, the Latest version of the driver for MK4 from the official site. All programs with licenses.

Pages: 1