Hello Guest it is March 28, 2024, 02:37:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - clipsteven

Pages: 1
1
Mach4 General Discussion / Re: change the mother board to a Mach4
« on: May 30, 2017, 07:56:08 AM »
Why so long I thought that it would be simpler and faster. I had one or two days in mind

Would it be easier to change the complete mother board?

And yes, I asked AXYZ International to change the mother board. They given me two choices, one at 30 000$ they want to change all the setup or buy a knew one at 125 000$.

2
Mach4 General Discussion / Re: change the mother board to a Mach4
« on: May 30, 2017, 06:54:01 AM »
Here is the link to my pictures of the CNC board,
 https://www.dropbox.com/sh/o8lwbrd8l4xgamr/AADsAsQAHB9lpfb-ge0nWtQ3a?dl=0

I understand that I will have to help my self and take all responsibility on the action that I decide to do. But I really need some help on understanding the mother board.
And do you sell mother board for mach3 or mahc4.



3
Mach4 General Discussion / Re: change the mother board to a Mach4
« on: May 29, 2017, 06:16:59 PM »
First, I would like to say thanks for replying I really appreciated.

 I know that it is possible to change one of the cards to converted to mach3 or mach4, there is a person that has the same CNC that I have and he has done it.

Why don’t I asked him?  Well I did, but the answer that he gave me
(First, I don’t know you and why should I help you nobody helps me win I need help)
Last time that I speak with this gentleman.

So, I have some pictures of the mother board. I will put them on my web page tomorrow morning and give you a direct link to them
The main reason that I wont to change the mother board is to be able to do 3D. this programme is good to du 2D but does not accepted 3D.
I am a specialist in 3D drawing and transferring the drawing in a G code but can’t do 50% of my drawings.
 ???

4
Mach4 General Discussion / change the mother board to a Mach4
« on: May 28, 2017, 01:17:54 PM »
First time on ArtSoft Not to familiar with it.

But I must try something. I am having trouble with my CNC. Thought you may be able to help me. This is my problem. I have a CNC from AXYZ International 2010. The control program does not permit me to du 3D carving, so I would like to change the mother board to a Mach4 that will permit me to have more freedom and I need help.
Thanks in advance ???

Pages: 1