Hello Guest it is March 28, 2024, 12:49:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TimT

Pages: 1
1
General Mach Discussion / Re: Z axis trouble
« on: May 03, 2017, 01:55:01 PM »
Yes, on START, the tool travels upward to trigger the LIMIT SWITCH.
It looks like there are also limit switches for Y axis, but I don't believe that is triggering since the tool head isn't near them.
Yes, the spindle turns on when I hit START.

2
General Mach Discussion / Z axis trouble
« on: May 02, 2017, 03:38:20 PM »
Dear Mach3 community:
I run a 4'x8' ezRouter Scorpion. Am a newer user (5 mos) cutting out primarily profiles of shapes and letters in plastic. My Z axis has been acting up for the past month, and I don't know where I went wrong. This week's issue is: each time I load a G-code and click START, the Z axis LIMIT SWITCH immediately TRIGGERS - I don't know how to overcome this.

Pages: 1