Messages

1

Tangent Corner / Re: Help and advise please

« on: April 27, 2017, 12:31:40 PM »

Thanks Gerry. Your comments make sense.
In getting started, I would only be cutting foam or wax for casting patterns.
In looking at the mechanics, where should I start for something to learn with and build on?

Chuck

2

Tangent Corner / Help and advise please

« on: April 27, 2017, 12:07:55 PM »

New member here. I have built an Arduino based controller for a rotary table, an am now exploring the possibility of building a CNC router/engraver. A friend on here built a system from surplus medical equipment.

I found a listing for 4 axis controller, including steppers on e-bay, and would like an honest opinion of it. I know next to nothing about CNC, but am a retired computer tech and hobby machinist, so I think I can figure it out.
 
Would those familiar with the hardware look at this listing and advise if it is a good deal?

http://www.ebay.com/itm/4Axis-Nema-CNC-Kit-23-Stepper-Motor-TB6560-287oz-in-Driver-board-/152525091236

It is my understanding the above referenced kit comes with MACH3.

Also, anyone know of a 3 or 4 axis mechanical setup that I could apply this kit to? I have a very limited budget, so re-building cheap surplus equipment is the idea.

I would even consider a previously loved setup if you have upgraded. Thanks in advance for any help.