Messages

1

Share Your GCode / Re: trouble making 8 lug spacer

« on: April 24, 2017, 07:32:42 AM »

Maybe it's the wrong tip on the tip on the cutter

2

Share Your GCode / Re: trouble making 8 lug spacer

« on: April 23, 2017, 09:13:27 PM »

I sure hope so. I can use so advice

3

Share Your GCode / Re: trouble making 8 lug spacer

« on: April 22, 2017, 07:24:57 PM »

Lol the same thing!  .565 inch hole. Even cutting thru 1/8 plate. I can't seem to get things set right. What feed rate and amp should I try it at. Seem like I've tried about everything. It's a Eagle plasma 4x4 with a Hypertherm Powermax 45

4

Share Your GCode / Re: trouble making 8 lug spacer

« on: April 22, 2017, 04:20:20 PM »

Ok guys why do my small hole always look like hell on this thing ?

5

Share Your GCode / Re: trouble making 8 lug spacer

« on: April 20, 2017, 03:18:32 AM »

Thanks for trying to help Tweakie. I found a video on flanges for  Qcad and got it done. But thank you very much for trying to help out.

6

Share Your GCode / trouble making 8 lug spacer

« on: April 17, 2017, 07:43:18 PM »

Im new to this mach3 thing and this is drivin me crazy so any help would be great. i need to cut out plates with 8 x .565 hole in 6.5 circle pattern for wheel spacer. the plate will be 8 inches across and have a 4.75 hole in the center. if anyone can help me with a program or even a pic. to use inkskape or sheetcam that would be a great help. i cant seem to figure out how to do it