1
Modbus / GT-7R5G-2 modbus with mach3
« on: July 15, 2019, 12:19:08 PM »
Hi, please how to ,set it up. VFD registers names, l would like to control the spindle, start, stop,amps, volts,frequency
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hey Ray,
I know you did not explain all that for me but THANKS. This is exactly what I was looking for.
I do not know how to add a LED to the screen. Could you help me? PLEASE...
I am also intrested in the edge and center finder macro that you were refering to if possible.
Thanks in a million