Messages

1

General Mach Discussion / Re: New to Mach3 and CNC No motor movement.

« on: March 22, 2017, 01:20:16 AM »

Ok. Uc100 installed. Still no motor movement.  What is the next step.  Chris.

2

General Mach Discussion / Re: New to Mach3 and CNC No motor movement.

« on: March 16, 2017, 12:24:15 PM »

Thanks for the response.  I've ordered a UC100. Recommended by mac3 support.  I'll get that tomorrow.  Run the test and send you a screen shot.  Thanks again!!   

3

General Mach Discussion / New to Mach3 and CNC No motor movement.

« on: March 15, 2017, 07:54:29 PM »

I purchased a old Minitech 25 year old, I am using Mach 3, had issues so so I started with a new 4-Axis NEMA23 CNC Kit (36V/9.7A/ 425 oz-in/ KL4030) kit from Automation Tech.  I wired up, all lights turn on and no smoke!!   lol    I think it is wired correctly.  I used the pins and ports from website  and used their xML file. 

I still have no movement of motors.  Power is going to motors, the movement is shown in MAc3 but not moving motors.  my volts were only 3 out of parallel port so I am using a 5 volt booster from cn4.  are those directional?  Just curious.  So I am at a bit of a loss.  This is the same problem I had before I bought all new board and motors. 

Any help would be awesome!!!.  If anyone has a wiring diagram I can check the wiring.  But for some reason I think I am missing something in Mac3??  I dont know.  Anything I can do for any help let me know.  THanks again.