Hello Guest it is March 28, 2024, 08:52:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Hahi

Pages: 1
1
CS-Lab / Mach3 starts moving without turning the hand wheel
« on: October 09, 2019, 12:08:27 PM »
I have a CSMIO IO-S controller with Mach3 running, Firmware Version updated to V2.910

When I select an axis on my handwheel my machine starts moving on this axis. When I turn off the axis, everything works normal, that means I can now make intended movements on all axes pressing the desired arrow buttons on my mach3 screen. as soon as I select an axis with my hand wheel, mach3 starts moving alone again, and I cannot influence this movement with the jog wheel.
it happened with the prior firmware version, too, but now, after the update, it still happens. my hand wheel has an option to change the resolution, and if I change it, the speed of the unwanted movements change, too. also the emergency button on the hand wheel is working, so there is a kind communication between the csmio and the hand wheel. in the mach3 info-tab of the mpg expansion module status is "active", firmware version is 1.10 if I click on the table row of the mpg expansion module there opens a window with shows the voltage of the analog inputs of the CAN bus, and it is always on 0V on the scale between 0V and 5V.
I tried to deactivate and reactivate the hand wheel in the software, also unplug and replugging did't change anything, and of course I tried to restart everything a few times...

any recommendations?

thank you!

2
German / Mach3 geht in Not-Aus
« on: March 02, 2017, 01:49:46 PM »
Hallo,

Meine Mach3 geht ab und zu in den Not-Aus Zustand.
Konkret passiert das imer nach dem Werkzeugvermessen: Mach3 zeigt mir in einem Popup den neuen Wert
für die geänderte Wekzeuglänge. Wenn ich dann auf OK drücke, fährt Mach3 auf die eingestellte Z0-Position hoch, und
genau dann passiert es. So wies aussieht übrigens genau auf der Höhe von Z0 geht Mach3 in den Notaus.
Manchmal wird in der Meldungszeile angezeigt " Externer Not-aus" oder so ähnlich.
Ich habe natürlich keinen gesrückt. Ich glaube nicht, dass es ein Wackelkontakt ist, denn wenn ich die Achse manuell (auch in höherer Geschwindigkeit als beim Vermessungsvorgang) anfahre, oassiert das nie- auch nicht, wenn ich über die -160 hinausfahre. Ich habe eine CSMIO IP-S Steuerung, Mach3 läuft unter Windows 7 32 bit.
Kennt jemand das Problem bzw. hat jemand eine Idee? Ich bin schon ziemlich verzweifelt deswegen...
Danke!

Pages: 1