1
General Mach Discussion / Re: Pause and re-start not working correctly
« on: February 07, 2017, 09:16:40 AM »
Dave,
Thanks for the feedback. After doing a few searches I found a piece on the SmoothStepper site(I'm using SmoothStepper) that describes a similar problem and they recommend installing an older more stable version of Mach3. I'm currently on 066 and they say 062 is better.
Thanks for the feedback. After doing a few searches I found a piece on the SmoothStepper site(I'm using SmoothStepper) that describes a similar problem and they recommend installing an older more stable version of Mach3. I'm currently on 066 and they say 062 is better.