Hello Guest it is July 22, 2019, 09:25:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mirzabala

Pages: 1
1
General Mach Discussion / Re: Drivers
« on: March 07, 2018, 01:48:09 AM »
Thanks

2
General Mach Discussion / Drivers
« on: March 05, 2018, 11:19:08 AM »
During the operation these words were written"driver watchdog" in mach3.what is this?thanks

3
General Mach Discussion / Calibration change
« on: April 09, 2017, 03:57:26 AM »
Hi,during the operation the machine cordinates change and it cuts wrongly,l checked that the calibration on Y axe changed.What is the problem?

Any suggestion??

4
General Mach Discussion / Re: too fast for pulleys...using max
« on: April 07, 2017, 07:19:13 AM »
Thanks

5
General Mach Discussion / change the coordinates
« on: April 07, 2017, 12:04:34 AM »
Hi,during the operations machine begins to change the cutting place and stops because of machine limit how  can l solve this problem,thanks

6
General Mach Discussion / Re: too fast for pulleys...using max
« on: April 06, 2017, 11:54:43 PM »
Thank you so much,but l am not using spindle automatically l use cutting machine and its rpm is 33000.l think l must deactive the spindle in config.is it ok?

7
General Mach Discussion / too fast for pulleys...using max
« on: April 06, 2017, 02:45:11 AM »
Hi,during the operations these words are flashing "too fast for pulleys...using max"
how can l solve this issue?thanks

8
General Mach Discussion / switches
« on: March 26, 2017, 07:32:57 AM »
Hi,tell me please can l use one switch for homing and limiting at the same time?
thanks

9
General Mach Discussion / motors tuning
« on: February 13, 2017, 03:12:44 AM »
HI,l want to use SFU1604-3 model ballscrew with nema 34HS9840 motors.Please tell me steps per,velocity and acceleration.unit is mm.thanks

10
General Mach Discussion / About the motors
« on: February 05, 2017, 01:51:49 AM »
HI,l use 34hs9840 model motor.l want to know the maximum and minimum velocity per mm in motor calibration,l use mach 3.thanks

Pages: 1