Hello Guest it is September 21, 2019, 06:09:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - GGW

Pages: 1
1
General Mach Discussion / Re: l297/l298 with mach3
« on: April 28, 2017, 03:54:29 PM »
I am having similar problems with using L298N drivers . I AM OPERATING MACH3 THROUGH AN INTEFACE BOARD INTO A L298N DRIVER. I GET STEP AND DIRECTION BUT THE MOTOR WILL NOT TURN. IT APPEARS THAT THERE IS NO PULSE VOLTAGE COMING FROM MACH3. I HAVE RESEARCHED L298N DRIVERS AND THERE IS NOT INFO AS TO WHETHER I HAVE TO USE AN L297 WITH THE L298N DRIVER IN THIS APPLICAATION. ANY HELP WOULD BE VERY MUCH APPRECIATED.

GGW

Pages: 1