Guest
Show Posts
1
General Mach Discussion / Re: Converting a DSP Controller system to Mach 3
« on: January 17, 2017, 01:36:55 PM »
Hi friends!
I'm needing to do the same thing with a chinese router. I readed all the talks but still can't understand all I need to do, also I have doubt if there is any difference between the router from Marvellca and to the I have to convert. Please could someone of you guys give me some help? Marwellca, have you succeeded with the conversion? All went right? Please can help me?
In advance, thank youfor attention!
Here are some imagens of the router.
I'm needing to do the same thing with a chinese router. I readed all the talks but still can't understand all I need to do, also I have doubt if there is any difference between the router from Marvellca and to the I have to convert. Please could someone of you guys give me some help? Marwellca, have you succeeded with the conversion? All went right? Please can help me?
In advance, thank youfor attention!
Here are some imagens of the router.