1
General Mach Discussion / Re: Odd action
« on: December 11, 2016, 01:36:36 AM »
Correction its when ever it hits the g28 code for homing.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi,
can you post the Gcode that you used?
Also have a look on the Config/General Config page and near the centre there two are settings:
Distance Mode should,or at least most commonly be 'Absolute' and
IJ Mode should , or again most commonly be 'Inc'.
Craig