Hello Guest it is March 29, 2024, 08:03:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kiely

Pages: 1
1
PoKeys / Re: Change or map axis on Pokeys57CNC
« on: December 12, 2016, 11:26:46 AM »
now i have fix it!

i use a changer relais between the y and z axis motor. the relais is connected to an output port of pokeys.

if i use the lathe profile, the relais change automatic the motorports when outputsignal in mach3 is on.

thanks for tips and helping

2
PoKeys / Re: Change or map axis on Pokeys57CNC
« on: December 03, 2016, 06:16:10 PM »
That does not sound good! Now i must buy the new version???

Is it not possible to program an assignment for the motor ports?

thanks kiely

3
PoKeys / Re: Change or map axis on Pokeys57CNC
« on: December 03, 2016, 05:45:23 PM »
Hello eurohoppel,

yes, i have two differnt profiles, but i can't change the second motor stepper port (57cnc) to the z-axis (3 position in mach3)

4
PoKeys / Re: Change or map axis on Pokeys57CNC
« on: December 03, 2016, 02:08:48 PM »
i'm work with mach3

5
PoKeys / Change or map axis on Pokeys57CNC
« on: December 03, 2016, 12:25:56 PM »
Hi all,

i have big problem or i dont understand th manual.

I use the Pokeys57CNC on a combi lathe/mill.
The axis x, y and z works perfect on the mill, but on the lathe i will be deactivated the z-axis from the mill and change the y-axis from the table to the z-axis.

If i use my old lpt interface, i could change the pins in the port&pin setup-->Motorsettings, but the 57CNC didn't use pins.
The stepper driver are connected to motor port1, motor port2 and motor port3.

I hope somebody can help. Sorry for my bad english.

Thanks


Pages: 1