Hello Guest it is December 01, 2021, 01:20:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kaspis245

Pages: 1
1
General Mach Discussion / Re: Arduino and Mach 3
« on: November 30, 2016, 03:23:41 AM »
Craig, thank you so much for your answer. The reason I desperately need Mach 3 to work is that I want to control my CNC with a joystick. I installed a plugin for Mach 3 and now it responds to my joystick commands very nicely. However, I can not find any other software that is capable of doing that. If it is really impossible to make Mach 3 work with Arduino, then the only option is to write a plugin myself. But it is rather unlikely since my programming skills are a bit weak.

2
General Mach Discussion / Arduino and Mach 3
« on: November 29, 2016, 02:43:26 PM »
I've purchased this CNC: https://www.amazon.co.uk/Beautystar-Machine-Engraving-Working-Milling/dp/B01FQPPW10/ref=sr_1_1?ie=UTF8&qid=1477335072&sr=8-1&keywords=Beautystar+CNC+DIY+Router+Machine
It has an Arduino UNO panel and I am having difficult time getting it respond to my commands in Mach 3. This Arduino panel is connected to my laptop via USB. The whole system works fine with other CNC controllers like Grbl Controller 3.0, bCNC-master but I can't get it to work with Mach 3. Is it even possible to make Mach 3 work with Arduino? Please help.

Pages: 1