1
General Mach Discussion / Re: Another Feed rate velocity issue
« on: November 24, 2016, 07:30:00 AM »
Hi mike,
Thanks for the response.
All metric here
Sets per mm 480.347716
USB board is a WXHC MKX-IV
No idea what it's max stepping rate is?
I have got the speeds resembling closer to what they should, factory had the kernel speed set at 100khz
Reducing it to 25000hz makes it somewhat resemble my other machines.
I still have the minor issue of it not taking a minute to travel 25mm when the feed rate is 25
It takes around 50secs no matter what I do.
Cheers
Thanks for the response.
All metric here
Sets per mm 480.347716
USB board is a WXHC MKX-IV
No idea what it's max stepping rate is?
I have got the speeds resembling closer to what they should, factory had the kernel speed set at 100khz
Reducing it to 25000hz makes it somewhat resemble my other machines.
I still have the minor issue of it not taking a minute to travel 25mm when the feed rate is 25
It takes around 50secs no matter what I do.
Cheers