This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Chrisisdashiznt
Pages: 1
1
« on: November 22, 2016, 10:54:54 AM »
I'll load it as soon as I get home it's a super simple drawing I've done 3 so far with the same result with each one just trying to get something to cut lol
2
« on: November 21, 2016, 02:38:39 PM »
everything went smoothly until I got into mach 3 I'm getting the error code of units:inches I'm going from qcad to sheet cam to mach 3 it is a tap file everything seems fine on my end just not sure where to go from here
Pages: 1