Hello Guest it is March 28, 2024, 06:57:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ltdan

Pages: 1
1
General Mach Discussion / Mach 3 Spindle & A-axis
« on: November 20, 2016, 12:08:20 PM »
Hello all
So I think I have tried everything.....I have a servo motor and drive driving my spindle
.When I set the ports and pins for A-axis and enable it works great when I also set my spindle to the same port n pins A-axis continues to work but no spindle.
If I disable A-axis then the spindle works great. It is just when I enable the A-axis motor output the spindle doesnt work.
Any help I would be grateful
System is
Mach3
PMDX-126
Ethernet SS
Dyn-4 Drives

Pages: 1