1
HiCON Motion Controller / Re: motor config problem with mach4 + Hicon
« on: March 08, 2017, 01:52:33 PM »
Dominique,
Before I make the step/dir cable connections, Just let me confirm that in single ended sourcing outputs
and inputs to my driver, I would jumper the step- to dir-(on controller), send dir- to com(0v) on the driver, send dir+
to dir+ and step+ to step+, does that sound good?
Steve
Before I make the step/dir cable connections, Just let me confirm that in single ended sourcing outputs
and inputs to my driver, I would jumper the step- to dir-(on controller), send dir- to com(0v) on the driver, send dir+
to dir+ and step+ to step+, does that sound good?
Steve