Messages

1

Mach4 General Discussion / Re: THC module on plasma

« on: February 24, 2024, 06:59:36 AM »

I think M03 and the THC module might conflict with each other. You can check to see if there are any settings in the Mach4 configuration related to THC behavior and M03 usage.

Thanks for your answer but can you explain me a little how i do this?

You use it and no problems at all?

2

Mach4 General Discussion / Re: THC module on plasma

« on: February 18, 2024, 04:32:33 AM »

Look in the FTP section.

Hi, unfortunately i can't get rid the problems. I try a lot of development version's, I can't find information about new settings it have and now i can't start moving after arc ok signal..

You know anyway to bypass the mach4 thc module?

3

Mach4 General Discussion / Re: THC module on plasma

« on: February 09, 2024, 03:21:08 PM »

Look in the FTP section.

Find it thanks a lot

4

Mach4 General Discussion / Re: THC module on plasma

« on: February 09, 2024, 11:55:27 AM »

Try build 5303.

Thanks for your help but i don't see it at downloads, the last one show the one i use. I have hobby Mach4.. maybe for that ??

5

Mach4 General Discussion / Re: THC module on plasma

« on: February 09, 2024, 10:43:46 AM »

What version of Mach are you using?

Mach4 V4.2.0.5036

6

Mach4 General Discussion / THC module on plasma

« on: January 20, 2024, 04:13:25 PM »

Hi, is anyone use the module of THC in Mach4??

Can't find any useful info about that to fix my problems..
How i can say to mach4 that now i want to listen to thc (Input up/Input Down), without M03. Is a registry about that?

The problem is when i use M03, the movements of ohmic and torch on/off is erratic, after probe move is stuck, after probe not go to pierce height e.t.c.
If i cut without M03, is working great but no THC.
I have pokeys57cnc with plasmasens and i try with external THC too, same problems.

Thanks a lot guys!!

7

Mach4 General Discussion / Re: reverse axe direction

« on: July 12, 2022, 04:17:57 AM »

Just try this and no change.

What controller you use, check the controller plugin it may need to change it there. Or maybe you have something wired wrong and work only one direction..

8

Mach4 General Discussion / Re: reverse axe direction

« on: July 12, 2022, 04:04:27 AM »

Or you mean about keyboard control??

If yes go to Configure - Plugins - Keyboard and change there.

9

Mach4 General Discussion / Re: reverse axe direction

« on: July 12, 2022, 04:03:38 AM »

Hi
how can i reverse the axe direction for my mini lathe.
The -z and the +z runs the same direction and also the -x and the +x runs the same direction.

Go to Configure - Control - Motors and down, between Backlash and Enable delay is a tick for reverse.

10

Mach4 General Discussion / Re: Need Help for Mach4/PoKeys/JMC Plasma-CNC, THC Cutting Start interrupted

« on: June 14, 2022, 01:27:39 PM »

Try with ohmic off and use a custom macro or try it manual to see if do the same.