Messages

1

Forum suggestions and report forum problems. / Re: Absolute coordinates in G2/G3 circular interpolation

« on: July 04, 2007, 03:19:54 PM »

OK.

I hadn't seen this setting.

You can also change the default IJ mode in the general config screen.

2

Forum suggestions and report forum problems. / Re: Absolute coordinates in G2/G3 circular interpolation

« on: July 03, 2007, 04:50:25 PM »

Graham,

That's great!!! It works!

Tell me : Have I missed something in Mach3's documentation? Is this "trick" written somewhere?

Best regards,

Gaël

3

Forum suggestions and report forum problems. / Absolute coordinates in G2/G3 circular interpolation

« on: July 03, 2007, 12:24:27 PM »

Dear all,

My problem is the following:

It appears that when passing a circular interpolation in the format "G2 X Y I J", the interpolation center (I J) is always interpreted by mach3 as a relative coordinate and never as a an absolute coordinate. Even with the proper G90, X and Y are correctly interpreted as absolute coordinates while I and J are treated as relative coordinates.

What can be done to make Mach3 G-Code interpretation to fit with the norme?

Best regards,

Gaël