Messages

1

Finished Plugins for Download / Re: USB JoyPad and game device plugin - New Version 2.0

« on: October 20, 2016, 06:50:01 AM »

OK. I understand now. I have changed buttons 5-6 to 7-8 and viceversa and still the same. Do you think this could be related to Hotkey configuration in Mach3? I will try to assing X Y Z movement with keygrabber to the knobs to check if this problem continues.
Thanks very much for your help. 

2

Finished Plugins for Download / Re: USB JoyPad and game device plugin - New Version 2.0

« on: October 19, 2016, 09:48:26 AM »

I am sorry, do you refer to CONFIG from Config Plugin in Mach3 for the this plugin or other plugin setup?. I don't fully understand...

3

Finished Plugins for Download / Re: USB JoyPad and game device plugin - New Version 2.0

« on: October 19, 2016, 09:03:29 AM »

Hi. Thanks for the help, but it isn't working. I did what you said.
When i calibrate the joystick knobs at middle point i gives a number of X:127 and  Y:127 for left one. At top left position X:0 and Y:0. And at bottom right X:255 and Y:255. Is this usual for all joysticks? Or this is maybe causing the problem because the programing is considering different numbers or conditions for the behaviour of this knobs.

4

Finished Plugins for Download / Re: USB JoyPad and game device plugin - New Version 2.0

« on: October 18, 2016, 07:22:08 AM »

Hi. First, i would like to thanks Joakim for everything he did and does for this community.
Second, i want to comment my problem, hope someone can help me: I have a controller wich works fine. Under windows calibration everything appears normal. After install plugin, activate in Mach3 and all that stuff, everything works fine BUT!!! the continuous jog. I can switch between Step and Continuous and in step it does what it should, and directions are correct, as configured in Plugin Config. But for the other mode, it is like the moving knob for X Y Z motion is not working.
Is there something you think i could be doing wrong?
Thanks again!!!