Hello Guest it is March 29, 2024, 07:08:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NigelW

Pages: 1
1
General Mach Discussion / Re: Reinstalling Mach3
« on: October 05, 2016, 03:28:17 AM »
Windows XP

2
General Mach Discussion / Re: Reinstalling Mach3
« on: October 04, 2016, 02:06:59 PM »
Good question! Just impulsive I guess and clearly not very bright, but it seemed a simple and obvious thing to do (the old turn it off and on again trick). I wasn't anticipating it being so complicated. But we are where we are and I'm afraid I'm a bit stuck.

3
General Mach Discussion / Reinstalling Mach3
« on: October 04, 2016, 01:19:57 PM »
After encountering some problems with Mach3 (I am a complete beginner), I decided to uninstall and reinstall Mach3 to see if that helped. I've clearly done something wrong because the reinstall hangs after a few seconds with the message 'A sharing violation has occurred while accessing an unnamed file'. I can only assume that I have uninstalled incorrectly. Can anyone help? Nigel

4
Mach3 under Vista / Re: xml file for 3020T-DJ engraving machine
« on: October 01, 2016, 04:07:22 PM »
Yes. And on screen it all seems to work - it just doesn't translate into any movement of the stepper motors. Though having said that, I have now managed to get two of the three motors to work (no X axis) by running my .tap file with Mach3 plasma rather than Mach3 mill. I don't know the difference. All I am currently trying to do is a simple engraving in wood of a person's name.

Nigel

5
Mach3 under Vista / Re: xml file for 3020T-DJ engraving machine
« on: October 01, 2016, 01:13:59 PM »
Did you ever receive any advice about this? I have the identical problem and, as a complete novice, have no idea how to cure it. Any help would be greatly appreciated.

Pages: 1