Hello Guest it is November 30, 2022, 10:00:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rocmen

Pages: 1
1
General Mach Discussion / Re: Auto Z Probing retract height
« on: September 24, 2020, 12:01:38 PM »
mikec here now it moves .24 inch instead of 1inch when i zero it whats up with machine
help

2
General Mach Discussion / Re: Auto Z Probing retract height
« on: September 24, 2020, 10:46:05 AM »
thanks that worked but when  it touches plate it only retracts to 7/8 instead of 1inch is it the script
thanks mikec

3
mikec here i fixed it mach3 general config go to de bounce it was at 0 i set it to 150 it stop tripping the limit switch
i must have alot of noise thanks for your help.

4
Change the state of Probe pin (if Unchecked Active Low check it, and vice versa). i did no work  maybe i need to ground the chassis where BOB is 

5
General Mach Discussion / Re: Auto Z Probing retract height
« on: September 24, 2020, 09:30:19 AM »
hi mike c here hookup z touch probe (i watch a video from guru brew) but when i touch the ground lead to the spindle the limit switch trips
and the digitized button is on when i touch the probe ground to the plate it goes off
can you help thanks mikec

6
General Mach Discussion / Re: touch probe install on mack 3
« on: September 24, 2020, 09:28:30 AM »
hi mike c here hookup z touch probe (i watch a video from guru brew) but when i touch the ground lead to the spindle the limit switch trips
and the digitized button is on when i touch the probe ground to the plate it goes off
can you help thanks mikec

7
rocmen herei built a cnc router set it up when i reference all  my y axis has 2 motors they go the same way until l it hits the limit/home switch then the a axis go in reverse do i need a separate
home switch thanks for help rocmen

8
hi i am new just built a cnc router was running fine till i switched from xp for win 7   i have no response on the mach3 screen
i changed ports and pins  no response on the screen 
can u help thsnk mikec

Pages: 1