1
Mach4 General Discussion / Re: Manual Tool Change with Probe: How to check if position is correct?
« on: January 21, 2020, 09:36:12 AM »
My current script runs "mc.mcCntlGCodeExecuteWait(inst, "G90 G53 X...")" without problems but when the line for the probe comes up "mc.mcCntlGCodeExecuteWait(inst, "G91 G31 Z-20 F20")" I get the error
---"Capping Z minimum to 0.0000 based on parameter 1801"
I check my SoftLimits but that's all good...when I run the code in the MDI it works...
Any ideas??
---"Capping Z minimum to 0.0000 based on parameter 1801"
I check my SoftLimits but that's all good...when I run the code in the MDI it works...
Any ideas??