1
FAQs / Re: Mach 3 only loads half of the gcode
« on: November 16, 2016, 09:39:25 AM »
I to have the same problem with my system. It only cut 500 lines even though it is licensed, I bought the license from the mach3 website. It comes up as licensed with my name
but still only 500 lines. I can disable the port and it sets all lines but won't cut any thing. Enable and it runs as demo but it is licensed.
but still only 500 lines. I can disable the port and it sets all lines but won't cut any thing. Enable and it runs as demo but it is licensed.