Hello Guest it is March 29, 2024, 06:23:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AMOS design

Pages: 1
1
Thank you Hood, I will give them a try this evening.
Bizarre error... I am at the point of uninstalling and reinstalling.

2
Post Processors / HSMWorks post processor?
« on: August 23, 2016, 03:09:53 AM »
Morning,
Has anybody got a post processor for Mach3 turn from HSMWorks?
Many Thanks

3
It is the OD turning / OD fillet wizard that causes the issue.  ???

4
See attachment. Thanks  :)

All the rest are ok. The other wizards work fine.

5
Thank you for your help.
I cannot get values in to Roughing Cut Depth and Finish Feedrate boxes on the OD turning Wizard.

6
Yes, I would agree  :) The only problem is I cannot change the value in the roughing cut depth box. I enter a value, press enter and then the value disappears and goes back to 0.

7
Hi,
I am getting the following error displaying in the Mach3 Turn Wizard - *** Roughing Cut = 0 *****.
This started when I tried using the wizard to do some turning. No matter what I do it will not disappear, even closing the program and restarting the computer does not help.
Any thoughts from any one?

Pages: 1