Guest
Show Posts
1
Mach4 General Discussion / Door switch
« on: August 19, 2016, 12:02:23 PM »
Hello
I can't set the door switch on feed hold instead of E-stop.The reason is simple It's a wood lathe and when
the part is done machining I start the spindle and I sand the piece while the spindle running. I save a lot
of time doing it. Is anyone does have an issue with this in the past. I am actually installing Mach4 + ESS
Thank you for your time
Marc-Andre
I can't set the door switch on feed hold instead of E-stop.The reason is simple It's a wood lathe and when
the part is done machining I start the spindle and I sand the piece while the spindle running. I save a lot
of time doing it. Is anyone does have an issue with this in the past. I am actually installing Mach4 + ESS
Thank you for your time
Marc-Andre