Hello Guest it is March 28, 2024, 06:01:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - weldnman

Pages: 1
1
This problem is with a 5 X10 plasma table. X is the long axis and 0 is on the right end if facing the long side. The home switches are on the right end. When I reference X the gantry moves to the switch as it should.
Also everything with the Y and Z axis work correctly as well. The problem is when I load a file from SheetCam (everything looks correct in SheetCam) the work piece is off the left side of the table. What needs to happen is everything needs to shift right the length of the table.
I have played around with homing and limits but haven't found the right combination so I guess it's time to ask for help. Any thoughts on how to make this happen?

Pages: 1