Hello Guest it is March 28, 2024, 01:30:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kkinser99

Pages: 1
1
General Mach Discussion / Re: Pro Cut CNC plasma table help needed?
« on: July 05, 2016, 12:41:39 PM »
I am having trouble attaching the cnc schematic file even below 6000 KB so I am trying it another way. https://www.facebook.com/photo.php?fbid=10153597590956976&set=a.10153597590366976.1073741832.500286975&type=3&theater

2
General Mach Discussion / Pro Cut CNC plasma table help needed?
« on: July 05, 2016, 11:27:40 AM »
Hello, I Purchased a Procut cnc plasma table a few months ago and am in final stages of getting it up and running. Having some issues though. I have every axis running but am having trouble understanding the data interface connection on the back of the plasma. I have a hypertherm model 65. I have attached a schematic to help you see my wiring layout. I am confused about the connection I need to make from the cnc control to the plasma machine interface. I do not currently have a THC so does that mean I only need to connect to interface contacts 3 and 4 (Plasma Arc) or will 12 and 14 (Plasma transfer) need be required as well? Are the connections shown in my schematic correct? That being 3 and 4 are connect to relay at control box and 12 and 14 have a 5v connection and a connection going to #15 on pin out board. Also if I am on the right track Where do I establish these connections in mach pins and ports? Also is there other general configuration settings I need to change for plasma use?

Pages: 1