Hello Guest it is March 29, 2024, 09:05:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bill I

Pages: 1 2 3 »
1
Mach Screens / Re: Move Speed
« on: December 26, 2016, 03:31:07 PM »
Thanks for all the help the + & - keys worked.

2
Mach Screens / Move Speed
« on: December 23, 2016, 10:43:22 PM »
Is there a way to slow down the move speed of the X & Y when using the + laser on the 2010 Screen Set?


3
General Mach Discussion / Re: Cutting smaller
« on: October 13, 2016, 03:31:50 PM »
 Recalculated motor tuning manually cut better but still off discovered backlash was turned off.

4
General Mach Discussion / Re: Cutting smaller
« on: October 13, 2016, 08:28:15 AM »
problem resolved
Thanks

5
General Mach Discussion / Re: Cutting smaller
« on: September 26, 2016, 09:35:02 AM »
Hi Rich

That was the first thing that was done after installing the new controller and has been re calibrated several times since with no change in steps per inch.

6
General Mach Discussion / Re: Cutting smaller
« on: September 26, 2016, 09:28:19 AM »
Resistors are used to regulate the amount of amps to a motor from 0 to 7 amps in my case I needed to supply 5.5 to 6 amps.
The resister used was 270K.

Bill I

7
General Mach Discussion / Re: Cutting smaller
« on: September 26, 2016, 08:06:45 AM »
Hi rcaffin

Backlash was one of the things that was looked at when I worked with Gecko on this problem.
There is no backlash or bit deflection the resistors were changed and the belts were checked for tension and wear in the belt reduction.

Bill I

8
General Mach Discussion / Re: Cutting smaller
« on: September 24, 2016, 09:10:29 PM »
I used the MACH Set steps per unit just like I did with the previous controller.

9
General Mach Discussion / Re: Cutting smaller
« on: September 23, 2016, 12:25:02 PM »
Hi ger21

Old controller did not support proxi. switches ,tool changer, spindle speed control also used old Gecko202 drives that had caused problems.

10
General Mach Discussion / Re: Cutting smaller
« on: September 23, 2016, 10:19:23 AM »
Hi ger21

Using MACH 3 Ver. R3.043.062, USB Smooth stepper, PMDX 126,134 & Gecko 203V drives.
NEMA 34 640 oz 5.5 amp motors 3-1 belt reduction. motors and belt reduction checked they are fine.
Cut in both clim and conventional all cuts are 4 thousands smaller.

Pages: 1 2 3 »