Messages

1

General Mach Discussion / Novice to Mach3, may be asking too much??

« on: February 24, 2017, 01:45:24 PM »

It was going really well until life got in the way. -work / family etc. I hope to complete on next 2 months. Recommend the CS labs gear for compatibility with existing hardware.


Sent from my iPhone using Tapatalk

2

CS-Lab / PID Tuning, one axis perfect, the other causing a headache.

« on: September 25, 2016, 09:51:49 AM »

Sorry for falling off the face of the earth. Summer holidays and busy times at work have meant I've barely turned the key in the workshop door for months! Hope normal service will resume now.


Sent from my iPhone using Tapatalk

3

General Mach Discussion / Novice to Mach3, may be asking too much??

« on: September 25, 2016, 09:50:07 AM »

Sorry for falling off the face of the earth. Summer holidays and busy times at work have meant I've barely turned the key in the workshop door for months! Hope normal service will resume now.


Sent from my iPhone using Tapatalk

4

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 28, 2016, 02:26:24 PM »

Thank you Hood.
Your generosity with your time is priceless.
I'm away with work for a while now, so progress is hampered, but gives me opertunity to sketch out all my circuit modifications.
Do any of your own machines run 'conventional' controls or have you converted them all now?

5

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 27, 2016, 05:46:06 PM »

thank you for taking the time to show me how to go on. I confess I'm going to need to spend some time looking at the brains side of it. there doesn't seem to be enough information in the string to work at first glance, but that's me not understanding what I'm looking at!!

I've plenty of work for the next few evenings, wiring up the old to the new and tidying things up

6

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 27, 2016, 05:42:24 PM »

the existing control was nonfunctional, with support available minimal

7

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 27, 2016, 05:41:34 PM »

god that's hard work.
so machine has a manual Dorean indexer on, in generally good condition

8

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 27, 2016, 05:37:51 PM »

5

9

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 27, 2016, 05:36:24 PM »

4

10

General Mach Discussion / Re: Novice to Mach3, may be asking too much??

« on: July 27, 2016, 05:35:05 PM »

3