Hello Guest it is March 29, 2024, 09:55:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kraftster

Pages: 1
1
Thank you!

2
Good day
I am still very new to mach 3 however I have a lathe running with the software.
I need to make a macropump which will monitor whether the spindle is actually turning,when it is set to be ON.
The purpose of it is to make sure the tool does not crash in the stock in the event that there is for eg. a damaged cable and the spindle stops
but the G Code continues to be executed. There is an encoder attached to the spindle.

what i am struggling with is structuring/writing the VB Macro and implementing it.
Any help would be greatly appreciated.

Pages: 1