Hello Guest it is March 28, 2024, 10:39:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ccronin4

Pages: 1
1
Mach3 under Vista / Re: xml file for 3020T-DJ engraving machine
« on: October 01, 2016, 09:03:01 PM »
thanks  did get the router running i have since converted a seig c3 hobby lathe to CNC now i have twice the problem i have tried it with mach3 no go anything.I   need advice to test the stepper motors+ driver without the computer
 i intend to test this ,then hook up mach 3 lathe any ideas????

2
Mach3 under Vista / xml file for 3020T-DJ engraving machine
« on: June 17, 2016, 04:05:47 AM »
I have racked my brain to get my XP to communicate with Chinese 3020T-DJ 3 axis CNC machine(T-D Axis controller) nothing works mach3 goes through gcode  but no stepper motors move not even in manual mode
 i am  after a XML file that actually works on this machine I would upload my xml file if i knew how

Pages: 1