Messages

1

General Mach Discussion / Re: axis won't reverse

« on: June 01, 2017, 04:17:47 PM »

In ports & pins where you setup the motor pins set the X axis only to active low, should go in the correct direction then when you use cursor keys.

2

General Mach Discussion / Re: How do I get Mach3 to work

« on: June 01, 2017, 04:00:30 PM »

Jim, just a thought, have you configured the hotkeys in mach3 under config? If the cursor (arrow ) keys haven't been set they won't work. I have the 3040T parallel only, once setup it works great.