1
General Mach Discussion / Re: Z axe's
« on: April 25, 2016, 10:46:16 AM »
I am having the same issue. What is happening is one of our old machines (series 1) runs off mach3 and we just got it back from a costumer who traded it in for a new (series 2) machine. So now we are trying to get his mach machine back up and running. Everything seems to jog fine but when you PGUP z goes up but is reading negative values. When you PGDN z moves down but reads a positive value. Caused a crash and now we are very hesitant to run more programs until we have this resolved any ideas would be great. Thank you,
Grant
grantnewcnc.com
Grant
grantnewcnc.com