Hello Guest it is March 28, 2024, 05:24:34 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - trike2

Pages: 1
1
G-Code, CAD, and CAM discussions / Re: reset x&y to zero in gcode
« on: March 27, 2023, 12:27:37 PM »
Thanks. That worked just like I wanted it to.  Now I have to learn more about macros and figure out what numbers correspond to what screen buttons so I can
write my own macros.

2
G-Code, CAD, and CAM discussions / Re: reset x&y to zero in gcode
« on: March 26, 2023, 08:27:56 AM »
At the end of my code I have a line that sets x&y to my start point for the next part then I manually reset the dro to zero and press start. I would like to have that step automatic so I could walk away and the machine would keep cutting parts. I am cutting small parts out of wood with a laser.

3
G-Code, CAD, and CAM discussions / reset x&y to zero in gcode
« on: March 25, 2023, 12:04:57 PM »
In Mach3, can the x&y axis be reset to zero in the gcode program?
I am trying to run a program multiple times without having to reset to zero manually.

4
Newfangled Solutions Mach3 Wizards / write wizard
« on: May 28, 2020, 07:47:49 PM »
I can use the write wizard to engrave but when I save the .tap file and load it again, it put a bunch of circles in the cut. I am renaming the default "write.tap" file so I can find it again. It seams to be adding lines of code. I would like to not have to rewrite every time.

5
Hi all

I am new to cnc and have built a gantry mill/plasma table. I have just finished hooking everything up and am getting it going. I WILL have questions latter. I seem to have a glitch when homing.
I have built miniature gas and steam engines, two motor trikes, gattling gun and many other projects. I needed a new challenge and learning cnc machining seems to be a good challenge.
My job to make money to fund the fun is an electronic technician. I will be back with details on my homing glitch

trike2

Pages: 1