Hello Guest it is April 19, 2021, 12:16:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lkigam

Pages: 1 2 »
1
Hellow im trying to sell my blue Integrea HICON board with plasma hole software and ebay is asking me for the Manufacture Number do any one know it thanks

2
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 10, 2017, 04:38:15 PM »
thank you very much i will try it thanks have a great weekend

3
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 10, 2017, 04:20:28 PM »
is not a link on line where i can see how to set up all integra i'm sorry but i dont understand the manual
what to input on the  J2 J3
i have my steper motor conected to a steper driver that go to J2 on the integra
but motor dont do nothing on mach4 is only running one axes i import a gcode that is working on mach3 so is not that problem

4
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 10, 2017, 04:15:30 PM »
so i open mach4 and then where i go ?  to help ?
im looking for screen how to set up the integra to move the motors thanks

5
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 08, 2017, 06:37:09 PM »
any link where i just can see screeen shots of the mach4 with the integra ?  thanks

6
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 08, 2017, 06:36:40 PM »
I try on a pc and cant open any file .prof

7
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 08, 2017, 06:14:13 PM »
http://www.vitalsystem.com/portal/motion/hicon/hicon_integra/Mach4_Integra_Mill.m4prof

or what software I need to open m4prof

I'm using a MacBook to surf the web
the pc where is mch4 don't have internet access

thanks

8
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 08, 2017, 06:10:39 PM »
can't open the link
something star to download and cant open thaks
can you send me the link again thanks

9
HiCON Motion Controller / Re: Mach4 + Hicom7766 + Proma THC 150
« on: September 04, 2017, 06:17:44 PM »
HI do any one have screen shots of how to set up the inputs and outputs on mach4 and Integra board I don't understand the manual how to set up the board to be able to use the motors I have a plasma table but I don't think that is a difference I can't make any of my motors move I'm using micro steppers drivers after the Integra they light up but no luck moving the motor thanks,
screen shot will be great thanks

10
Mach4 Videos / Re: MACH4 HICON INTEGRA
« on: September 04, 2017, 05:57:41 PM »
OK thanks do i close this ?

Pages: 1 2 »