Hello Guest it is April 19, 2024, 09:11:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tcustom

Pages: 1
1
dspMC/IP Motion Controller / Re: PID tuning for MR-J2S Servos
« on: April 17, 2016, 02:03:24 AM »
I already did it with velocity control mode.

There is nothing I can do anymore with velocity mode?

If I change to torque mode, I need to change wiring of servo drivers connector.

I want to do everything I can do in speed control mode first.

Thank you.

2
dspMC/IP Motion Controller / Re: PID tuning for MR-J2S Servos
« on: April 16, 2016, 09:59:13 PM »
Hello,

Thanks for your answer.

You mean that I need to set my servo amps to 'torque control mode'?

If then I also change wiring.

Mitsubishi servos use +-8v for torque command.




3
dspMC/IP Motion Controller / PID tuning for MR-J2S Servos
« on: April 16, 2016, 09:32:51 PM »
Hello,
Hope that somebody can understand my poor english.
I use Mr-J2s servos for my machine. I think my servos are well tuned, but I can't find any reasonable values for PID in DSPMC.
I already read DSPMC integration manual several times, and tried many times to make it stable. But I can't yet.

This is what I did.

1. First of all, I tuned servo drivers through Mitsubishi servo tuning program.
2. Open DSPMC  plugin window, then set velocity 10000, acceleration 1000, distance 0.1, P : 100, D and I : 0, lowpass filter : 5.
3. Execute move and increase P gain until axis can move.
4. Add D and I gains  gradually. (status graph doesn't change properly.)
5. After I make graphs (red and blue) as close as possible, then I put larger value for distance (ex: 1~3mm) and execute.
6. Motors are vibrate and make loud noise like grinder when they moving.

I already did this a dozen times. So I add Accel,Decel and S-pattern constants in MR-J2S drivers.(parameter 11,12,13)
After I add this, motor looks stable but it can't follow commands quickly.

Isn't there anybody use Mitsubishi servo motors?
Please give me a guideline.

Thank you.

P.S. What is the purpose of 'velocity feed foword'?

Pages: 1