Messages

1

PoKeys / Re: MPG problem

« on: April 22, 2016, 11:56:10 AM »

Hi NeoTo sorry I have some problems.

I am searching the mach3 and pokeys update but I only found a installer where  I need to have internet in the PC. Now, in the machine I'm working I dont have internet and is difficult connect it.
Do you know if I can download a file with the installer? and can I use the same license?
In the web page of POLABS I can't find the update to pokeys. Can you help me with this too?

thanks for your help.

2

PoKeys / Re: MPG problem

« on: April 06, 2016, 03:36:24 PM »

In mach3 I have  3.043 and in Pokeys i have 3.1.55

And yes it's enable Let Pokeys handle MPG jogging

In 'Encoder Settings' I have Encoder1 Enable Checked, Pin1, Pin2, Invert Unchecked, 4X unchecked, DRO 101:...,and Pedant Checked

Thank you.

3

PoKeys / MPG problem

« on: April 06, 2016, 02:06:34 AM »

Hi I'm working on a CNC mill with Pokeys 56U and  I want to make it work with an old MPG that has 4 terminals A,B,Ground and Positive. Now, I used the MPG manual and connected the terminals to Pokeys board in A=>Pin1, B=>Pin2 and made alll the configurations.
Now I can move the axis when I select the jog mode, but the problem starts when I change axis. When I chose the X axis and turn the handweel it moves correctly, but when I turn to Y axis (Alt A) it starts moving like 7in alone (without moving the handweel) and if I don't move the handweel and press Alt A again the Z axis moves too.

Do you have any ideas?
         

Thank you for your time.