Hello Guest it is April 19, 2024, 10:20:44 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mnms

Pages: 1
1
General Mach Discussion / Re: Direction change constant rate problem
« on: April 08, 2016, 05:10:01 AM »
Nobody? Other experience to achieve constant slow step rate without accel./decel. (mill profile)?

2
General Mach Discussion / Direction change constant rate problem
« on: April 03, 2016, 10:45:31 PM »
Hello, I noticed following behavior in Mach3 (explicit in slow speeds e.g. 1 step/sec):
When direction is changed (G01 X1, G01 X0) step rate is not constant - doubles on turnaround.
Can it be disabled?

Pages: 1