3
« on: April 03, 2016, 11:34:10 AM »
Well we are closer but not just there. I took a stab at the frequencies (I don't have a clue) set output pin 8 to 150 MHz in Darwin, toggled the output & the relay clicks in, motor spins slowly as before. Set output 9 to pin 9, called it spindle direction. Went into set frequency spindle, set min to 200, left max at 5000. Now spindle starts using the on screen button, also with an M3 command but still ignoring the S1000 command. Now here's the difference, if the spindle SRO is set high & I try turn on the spindle, I get a buzzing from the BOB, if I move the slider up & down the tone of the buzz changes, I presume because of the frequency change. If I put the slider in a low position the relay clicks in & spindle runs. Can you give me some idea what the frequencies should be ? my spindle has min 200 rpm & a max of 2000. I did notice Darwin adjusts the frequency on its own accord. I tried different frequencies, some high numbers where reduced by Darwin. I don't get any notifications in the error history as to setting frequency. When I run M3 S1000 it says set MDI.