1
Third party software and hardware support forums. / Re: optimum kontroller IV
« on: January 04, 2019, 01:14:33 AM »
Hi Gert
Yes, I do need help and would appreciate it if you could find the time to help.
My machines are a bf46vario converted to cnc(factory fitted ballscrews) with a controller IV. I also have a TU2708 vario lathe with the same cnc setup, however i’m contemplating using the same controller for the lathe.
I’ve setup my sherline machines about 5 years ago and have been using them, but bigger is always better so went for Optimum.
I’m not sure exactly what to ask for from you as I suppose its the setup within Mach3 which need to be configured, but if you have that information I would appreciate it.
If you need to know more from my side let me know.
Best Regards
Bernic
Yes, I do need help and would appreciate it if you could find the time to help.
My machines are a bf46vario converted to cnc(factory fitted ballscrews) with a controller IV. I also have a TU2708 vario lathe with the same cnc setup, however i’m contemplating using the same controller for the lathe.
I’ve setup my sherline machines about 5 years ago and have been using them, but bigger is always better so went for Optimum.
I’m not sure exactly what to ask for from you as I suppose its the setup within Mach3 which need to be configured, but if you have that information I would appreciate it.
If you need to know more from my side let me know.
Best Regards
Bernic